TIO Radio Telemetry Input/Output Module from Celsum Technologies - Instrumentation for rheology, strain gages, pressure transducers, load cells, temperature control, sapphire window optical probes, precision extrusion dies, and much more.

The TIO is a high performance, very flexible telemetry instrument that provides digital and analogue IO to a radio telemetry system. The nature and combination of the IO signals is determined by a range of plug-in modules, so the user can configure the instrument to suit their application. The TIO can be driven or read from a computer connected to a TCM as well as allowing other Telemetry devices to modify the IO parameters; the TIO has the capability of requesting data from other devices and modifying its outputs accordingly.

Key Features:

Selection of Digital and Analog Inputs & Outputs
Very high stability
Remote power on/off
Voltage free contact retransmission
Operates from 15 - 28V DC power supply
Power consumption in Receive Mode 60mA
Power consumption in Transmit Mode 76mA
Configured & calibrated via PC using TCM module
Supplied with free software toolkit
Electrical isolation gives high immunity
   to electrical storms
Error-free, 2-way radio system
Internal antenna supplied
Minitoring Watch Functions
External antenna can be fitted to increase
    performance
Protocol ASCII XP
Data rate 1 to 10 updates per sec
IP65/NEMA ABS glanded case
Impending power fail detection & shutdown
Low power detection & hold off
Size 150 x 80 x 55mm
Connections via screw & snap terminals
1 year manufacturer's warranty
Two models available:
            868 MHz for the European market
             20mW power, 300 metres (330 yards)
             range, 36 channels
            915 MHz for the USA & Canadian
             markets; 10mW power, 200 metres
             (220 yards) range, 130 channels

Plug-In Modules
The TIO will accept up to 1 Analogue Input, 1 Analogue Output, 1 Digital Input and 1 Digital Output module, each which may be located in any of the four slots.

Digital Inputs

TIODI1 8 digital inputs for zero voltage contacts or
2 - 24V voltage signals

Digital Outputs

TIODO1 8 open collector digital outputs.
Each output can sink up to 20mA,
Maximum voltage 24VDC

TIODO2 8 normally open relay outputs.
Rated 20V 1A
TIO supply voltage must be 18V DC min

Analogue Input

TIOAI1 0-10V and 4-20mA analog input
              10 bit (1 part in 1024) resolution
              Accuracy ±0.06% of Full Scale
              Linearity ±0.06% of Full Scale

Analogue Output

TIOA01 0-10V and 4-20mA analog output
              15 bit (1 part in 32768) resolution
              Accuracy ±0.03% of Full Scale
              Linearity ±0.02% of Full Scale
              Slew Rate: 0.1 - 10V 200ms
              Slew Rate: 10 - 0.1V 1000ms
              Slew Rate: 4 - 20mA 250ms
              Slew Rate: 20 - 4mA 400ms
              Supply required 15VDC minimum
              4-20mA output at 18V supply can
                drive into 500R load