The
SMP Surface-Mounting Intelligent Process Amplifier is a rugged
instrument which allows many common process signals to be connected,
the signal to be conditioned and displayed, and control actions performed.
A relay module provides for two set points, complete with In-Flight/Hysteresis
compensation. The working units may be set as engineering units. Communication
with intelligent hosts is possible via the ASCII, MODBUS and MANTRABUS
protocol options.
Key
features of the SMP:
Large LCD Display (12.7 mm)
High performance, low drift
Choice of power supplies - 115V AC, 230V AC and 9 - 32V DC
Isolated analogue outputs, both 4-20mA and 0-10V
Wide range of input signals:
0 - 10 V
0 to 20 mA
± 200 mA
LVDT
Dual LVDT
Rate/Totaliser
J or K Type Thermocouples
PT100 Resistance Thermometer
Fast (10 ms) Strain Gauge
Dual channel 4 - 20 mA (800 ms/channel)
Dual channel 0 - 10 V (800 ms/channel)
Remote driver
Contact inputs for print and peak hold reset
Resolution 4½ digits (15 bits)
Simple one-pass Auto Calibration
PID Control
Digital programming, calibration and display
No interaction between Gain and Zero Offset
Connect up to 250 SMPs to one serial port with the IF25
10 years data retention
Built-in Sensor Excitation will drive up to six 350-ohm gauges
Strain gauge impedance from approx 60 ohms
upwards
Plug-in modules allow custom configuration:
Relay set points, programmable in
engineering units
Communications 20mA Current Loop or RS232/485
Comms protocols ASCII, MODBUS RTU or Mantrabus
Comms baud rates 300 to 19,200
Printers
Remote display module
DIN
Rail Mounting for CPU
Programmable function key disabling
Two passwords - user and calibrator
Watchdog timer incorporated
Robust single-card base PCB
Surface Mount components
IP65 surface mounting field case with cable glands
ABS case, dimensions 200 x 120 x 75 mm
Full CE Approval
Saves cost and space
Easy to use
3 year Warranty
Please
ask us for a Quotation
